Research

Paper · MFC

Influence of synthesis temperature of eggshell-derived hydroxyapatite on biofilm formation and microbial fuel cell performance.

01

Summary

What the paper reports, in its own words.

3D Interactive ModelAI Enhanced· 75%Wastewater Treatment

Abstract

Microbial fuel cells (MFCs) enable simultaneous wastewater treatment and bioelectricity generation, but their performance is often constrained by poor bacterial adhesion and slow anode electron transfer. Hydroxyapatite (HA) can address these limitations; however, most studies rely on commercial HA and rarely examine biowaste-derived sources or synthesis-route effects. In this study, eggshell-derived HA was synthesized via room-temperature precipitation (CHP) and hydrothermal treatment at 250 °C for 3 h (CHH), then blended with carbon to fabricate composite anodes. Dual-chamber MFCs inoculated with Shewanella putrefaciens were evaluated using electrochemical analyses (CV, EIS, polarization) and biofilm characterization (CFU counts, crystal violet staining, SEM). CHH achieved a peak power density of 0.164 W m -2 , approximately 167% higher than bare carbon and 23-33% higher than carbon and CHP. CHP exhibited slightly lower peak power but superior sustained output over a wider current-density range, attributed to its low-crystallinity structure and rapid early colonization. The results demonstrate that HA nanostructure, governed by synthesis route, directly influences biofilm formation and electron transfer. Overall, eggshell-derived HA anodes significantly enhance MFC performance, establishing a clear synthesis-nanostructure-biofilm-performance relationship.

AI summary

75% confidence

The study examines the effect of synthesis temperature on eggshell-derived hydroxyapatite for microbial fuel cell performance, finding that hydrothermal treatment at 250°C enhances power density. The results show that the synthesis route affects the nanostructure of hydroxyapatite, influencing biofilm formation and electron transfer. The optimal synthesis method depends on the desired balance between peak power and sustained output.

Generated by MESSAI extraction pipeline · review against source PDF

02

Extracted values

Every value pulled from the paper, with its source, so each number can be checked against the text.

n = 6 extracted values

Select a citation to see the quote, page and confidence behind a value.

0 of 6 extracted rows modelable

  • 3 not canonicalised (no canonical slug)
  • 3 no SI value
ParameterValueUnitConfidenceSourceModelable
Dominant organismShewanella—80%
extracted
Excluded: not canonicalised (no canonical slug)
Reactor typedual-chamber—80%
extracted
Excluded: not canonicalised (no canonical slug)
Chambers2—80%
extracted
Excluded: not canonicalised (no canonical slug)
Substratewastewater—70%
extracted
Excluded: no SI value
Maximum power density164mW/m²50%
extracted
Excluded: no SI value
Anode materialeggshell-derived hydroxyapatite blended with carbon—50%
extracted
Excluded: no SI value

Methodology

What was the system and how was it run

Methodology

Methodology

The study uses a combination of electrochemical analyses, biofilm characterization, and dual-chamber microbial fuel cells to evaluate the performance of eggshell-derived hydroxyapatite synthesized via different methods.

Biological parameters

FieldValue
dominant species["Shewanella"]

Operational parameters

FieldValue
substrate["wastewater"]

Pipeline

Raw extractions, artifacts, quality signal

Extraction quality

honesty signal

Calibrate your trust in the extracted content against these signals — they're how the pipeline rated its own output for this paper.

Parameter completeness

38%

Fraction of expected parameters extracted

Data completeness

50%

Overall extraction coverage across fields

AI confidence

75%

Model self-reported confidence

Mean parameter confidence

68%

Average confidence across PaperParameter rows surfaced above

review against source PDF before citing · scores 0–1

03

Chart explorer

Move the inputs this paper used and see how the predicted outcome shifts.

04

Explore model

The reactor in 3D, with flow you can switch on and off.

05

AI insights

Contradictions, gaps and opportunities found by comparing this paper with the corpus.

06

Compare similar papers

The nearest papers by system, materials and organisms, with their outcomes side by side.

loading 3D model…

Representative model, generic MFC

Representative MFC — matched on the paper’s system type only, not its reactor or geometry.

MFC
System
164milliwatts per square metre
Best result · Power density
6
Extracted values
2026
Year

In this record

Organisms, parameters and materials this paper reports. Each links to its page.

Keywords

  • Biofilm formation
  • Eggshell-derived materials
  • Hydrothermal synthesis
  • Hydroxyapatite
  • Microbial fuel cell
  • Precipitation synthesis

Cite

(2026). Influence of synthesis temperature of eggshell-derived hydroxyapatite on biofilm formation and microbial fuel cell performance. Bioelectrochemistry (Amsterdam, Netherlands). https://doi.org/10.1016/j.bioelechem.2026.109235

PubMed
41610458

Open in lab for full controls, parameter editing, and template overlays.

Open in lab