Paper
Stainless steel corrosion via direct iron-to-microbe electron transfer by Geobacter species
- Geobacter Metallireducens Gs15
- Geobacter Sulfurreducens Pca
- Geobacter species
Summary
What the paper reports, in its own words.
Abstract
Abstract Microbial corrosion of iron-based materials is a substantial economic problem. A mechanistic understanding is required to develop mitigation strategies, but previous mechanistic studies have been limited to investigations with relatively pure Fe(0), which is not a common structural material. We report here that the mechanism for microbial corrosion of stainless steel, the metal of choice for many actual applications, can be significantly different from that for Fe(0). Although H2 is often an intermediary electron carrier between the metal and microbes during Fe(0) corrosion, we found that H2 is not abiotically produced from stainless steel, making this corrosion mechanism unlikely. Geobacter sulfurreducens and Geobacter metallireducens, electrotrophs that are known to directly accept electrons from other microbes or electrodes, extracted electrons from stainless steel via direct iron-to-microbe electron transfer. Genetic modification to prevent H2 consumption did not negatively impact on stainless steel corrosion. Corrosion was inhibited when genes for outer-surface cytochromes that are key electrical contacts were deleted. These results indicate that a common model of microbial Fe(0) corrosion by hydrogenase-positive microbes, in which H2 serves as an intermediary electron carrier between the metal surface and the microbe, may not apply to the microbial corrosion of stainless steel. However, direct iron-to-microbe electron transfer is a feasible route for stainless steel corrosion.
Extracted values
Every value pulled from the paper, with its source, so each number can be checked against the text.
n = 23 extracted values
Select a citation to see the quote, page and confidence behind a value.
0 of 23 extracted rows modelable
- 22 not canonicalised (no canonical slug)
- 1 no SI value
| Parameter | Value | Unit | Confidence | Source | Notes | Modelable |
|---|---|---|---|---|---|---|
| Corrosion Current Density×2 | 32 | nA·cm⁻² | 90% | extracted | "The icorr for the abiotic control and strain ACLHFΔomcS were similar, about 32 ±…" · T=25°C, pH(an)=7, substrate=stainless steel (316L) | Excluded: not canonicalised (no canonical slug) |
| Corrosion Current Density | 614 | nA·cm⁻² | 90% | extracted | "the icorr for strain ACL (614 ± 47 nA·cm−2)" · T=25°C, pH(an)=7, substrate=stainless steel (316L) | Excluded: not canonicalised (no canonical slug) |
| Corrosion Current Density | 760 | nA·cm⁻² | 90% | extracted | "strain ACLHF (760 ± 58 nA·cm−2)" · T=25°C, pH(an)=7, substrate=stainless steel (316L) | Excluded: not canonicalised (no canonical slug) |
| Corrosion Current Density | 741 | nA·cm⁻² | 90% | extracted | "the omcS complemented strain of strain ACLHFΔomcS (741 ± 50 nA·cm−2)" · T=25°C, pH(an)=7, substrate=stainless steel (316L) | Excluded: not canonicalised (no canonical slug) |
| Corrosion Current Density | 1,100 | nA·cm⁻² | 90% | extracted | "and icorr (1098 ± 87 nA·cm−2; Fig. 6I)" · T=25°C, substrate=stainless steel (316L) | Excluded: not canonicalised (no canonical slug) |
| Corrosion Current Density | 101 | nA·cm⁻² | 90% | extracted | "and icorr 101 ± 22 nA·cm−2; Fig. 6I)" · T=25°C, substrate=stainless steel (316L) | Excluded: not canonicalised (no canonical slug) |
| Open Circuit Potential | 161 | mVSHE | 90% | extracted | "The lowest OCP for the stainless steel in the abiotic control was 160.9 mVSHE" · T=25°C, pH(an)=7, substrate=stainless steel (316L), steady_state | Excluded: not canonicalised (no canonical slug) |
| Average pit depth | 0.9 | μm | 90% | extracted | "The average depth of the ten largest pits was only 0.9 ± 0.4 μm" · T=25°C, pH(an)=7, substrate=stainless steel (316L) | Excluded: not canonicalised (no canonical slug) |
| Pit density | 24 | pits mm⁻² | 90% | extracted | "The pit density of the abiotic control (24 ± 15 pits mm−2)" · T=25°C, pH(an)=7, substrate=stainless steel (316L) | Excluded: not canonicalised (no canonical slug) |
| Open Circuit Potential | -141 | mVSHE | 90% | extracted | "the OCP of the stainless steel colonized by strains ACL and ACLHF was much lower…" · T=25°C, pH(an)=7, substrate=stainless steel (316L), steady_state | Excluded: not canonicalised (no canonical slug) |
| 1/Rp | 0.009 | kΩ⁻¹·cm⁻² | 90% | extracted | "The 1/Rp of strain ACL was stable at around 0.009 kΩ−1·cm−2" · T=25°C, pH(an)=7, substrate=stainless steel (316L) | Excluded: not canonicalised (no canonical slug) |
| Pit density | 110 | pits mm⁻² | 90% | extracted | "The pit density of the abiotic control (24 ± 15 pits mm−2) was much less than fo…" · T=25°C, pH(an)=7, substrate=stainless steel (316L) | Excluded: not canonicalised (no canonical slug) |
| Open Circuit Potential | -117 | mVSHE | 90% | extracted | "the OCP of the stainless steel colonized by strains ACL and ACLHF was much lower…" · T=25°C, pH(an)=7, substrate=stainless steel (316L), steady_state | Excluded: not canonicalised (no canonical slug) |
| 1/Rp | 0.012 | kΩ⁻¹·cm⁻² | 90% | extracted | "strain ACLHF had a range from 0.012 to 0.029 kΩ−1·cm−2" · T=25°C, pH(an)=7, substrate=stainless steel (316L) | Excluded: not canonicalised (no canonical slug) |
| Pit density | 126 | pits mm⁻² | 90% | extracted | "The pit density of the abiotic control (24 ± 15 pits mm−2) was much less than fo…" · T=25°C, pH(an)=7, substrate=stainless steel (316L) | Excluded: not canonicalised (no canonical slug) |
| Average pit depth | 1.6 | μm | 90% | extracted | "the average depth of ten largest pits was 1.6 ± 0.5 μm" · T=25°C, pH(an)=7, substrate=stainless steel (316L) | Excluded: not canonicalised (no canonical slug) |
| Average pit diameter | 3.8 | μm | 90% | extracted | "with average diameter of 3.8 ± 1.0 μm" · T=25°C, pH(an)=7, substrate=stainless steel (316L) | Excluded: not canonicalised (no canonical slug) |
| Pit density | 40 | pits mm⁻² | 90% | extracted | "When omcS was deleted from strain ACLHF, the pit density decreased to 40 ± 17 pi…" · T=25°C, pH(an)=7, substrate=stainless steel (316L) | Excluded: not canonicalised (no canonical slug) |
| Pit density | 85 | pits mm⁻² | 90% | extracted | "Complementation of the omcS mutation increased the pit density to 85 ± 18 pits m…" · T=25°C, pH(an)=7, substrate=stainless steel (316L) | Excluded: not canonicalised (no canonical slug) |
| 1/Rp | 0.01 | kΩ⁻¹·cm⁻² | 90% | extracted | "The 1/Rp (ca. 0.01 kΩ−1·cm−2; Fig. 6H)" · T=25°C, substrate=stainless steel (316L) | Excluded: not canonicalised (no canonical slug) |
| 1/Rp | 0.003 | kΩ⁻¹·cm⁻² | 90% | extracted | "1/Rp (ca. 0.003 kΩ−1·cm−2; Fig. 6H)" · T=25°C, substrate=stainless steel (316L) | Excluded: not canonicalised (no canonical slug) |
| Specific H₂ Production | 0.1 | Pa | 90% | extracted | "the concentration of H2 in abiotic controls (approximately 0.1 Pa) containing st…" · T=25°C, pH(an)=7, substrate=stainless steel (316L) | Excluded: no SI value |
Methodology
What was the system and how was it run
Operating conditions
11 runs extracted| Run | T°C | pHan | pHcat | Substrate | [S]mg/L | HRTh | Mode | R_extΩ | V_appV | Inoculum |
|---|---|---|---|---|---|---|---|---|---|---|
| C01: G. sulfurreducens strain ACL on 316L stainless steel, 1 cm² electrode, fumarate reduction, 7 days | 25 | 7 | — | — | — | — | — | — | — | G. sulfurreducens strain ACL |
| C02: G. sulfurreducens strain ACLHF on 316L stainless steel, 1 cm² electrode, fumarate reduction, 7 days | 25 | 7 | — | — | — | — | — | — | — | G. sulfurreducens strain ACLHF |
| C03: G. sulfurreducens strain ACLHFΔomcS on 316L stainless steel, 1 cm² electrode, fumarate reduction, 7 days | 25 | 7 | — | — | — | — | — | — | — | G. sulfurreducens strain ACLHFΔomcS |
| C04: G. sulfurreducens strain ACLHFΔomcS complemented with omcS on 316L stainless steel, 1 cm² electrode, fumarate reduction, 7 days | 25 | 7 | — | — | — | — | — | — | — | G. sulfurreducens strain ACLHFΔomcS complemented |
| C05: G. sulfurreducens strains on 316L stainless steel coupons in serum bottles, fumarate reduction, 7 days | 30 | 6.9 | — | — | — | — | — | — | — | G. sulfurreducens strains |
| C06: G. metallireducens wild-type on 316L stainless steel, 1 cm² electrode, nitrate reduction, 7 days | 25 | 7 | — | — | — | — | — | — | — | G. metallireducens wild-type |
| C07: G. metallireducens ΔGmet 1868 mutant on 316L stainless steel, 1 cm² electrode, nitrate reduction, 7 days | 25 | 7 | — | — | — | — | — | — | — | G. metallireducens ΔGmet 1868 |
| C08: Abiotic control with 316L stainless steel, 1 cm² electrode, no inoculation, 7 days | 25 | 7 | — | — | — | — | — | — | — | — |
| v2-1b0f34c317afd596 | 25 | — | — | stainless steel (316L) | — | — | — | — | — | — |
| v2-276f07c62e6dace9 | 25 | 7 | — | stainless steel (316L) | — | — | steady_state | — | — | — |
| v2-37e99a7206f0cdf0 | 25 | 7 | — | stainless steel (316L) | — | — | — | — | — | — |
Pipeline
Raw extractions, artifacts, quality signal
Extraction quality
honesty signalCalibrate your trust in the extracted content against these signals — they're how the pipeline rated its own output for this paper.
AI confidence
60%
Model self-reported confidence
Mean parameter confidence
90%
Average confidence across PaperParameter rows surfaced above
review against source PDF before citing · scores 0–1
Chart explorer
Move the inputs this paper used and see how the predicted outcome shifts.
Explore model
The reactor in 3D, with flow you can switch on and off.
AI insights
Contradictions, gaps and opportunities found by comparing this paper with the corpus.
Compare similar papers
The nearest papers by system, materials and organisms, with their outcomes side by side.
Source PDF
The paper as published.
No 3D model is mapped to this paper yet. The values extracted from it are listed under Extracted values.
In this record
Organisms, parameters and materials this paper reports. Each links to its page.
Organisms · 3
- Geobacter Metallireducens Gs15
- Geobacter Sulfurreducens Pca
- Geobacter species
Keywords
- Corrosion
- Geobacter
- Geobacter sulfurreducens
- Metal
- Electron transfer
- Metallurgy
Cite
Haiyan Tang, Chuntian Yang, Toshiyuki Ueki et al. (2021). Stainless steel corrosion via direct iron-to-microbe electron transfer by Geobacter species. The ISME Journal. https://doi.org/10.1038/s41396-021-00990-2
- Journal
- The ISME Journal