Research

Paper

Upgrading Potential of Waste Fermentation-Based C4-C5-C6 Carboxylic Acid Mixtures using Electrochemical Oxidative Decarboxylation

01

Summary

What the paper reports, in its own words.

ElectrosynthesisBiomass Valorization

Abstract

Electrochemical upgrading techniques could provide a powerful tool to complement biorefineries processing waste materials, thereby making progress towards the electrification of these platforms. Among them, (non)-Kolbe electrolysis, that is, electrochemically driven oxidative decarboxylation of carboxylic acids, plays a key role as its product palette consists of alkanes (Kolbe products) as well as competing non-Kolbe products, including short-chain alkenes, alcohols, esters, ketones and aldehydes. The formation of alkanes takes place via the dimerization of radicals after the decarboxylation of carboxylic acids and requires relatively high acid concentrations (> 0.5 M) and a high current (> 200 mA cm⁻²). In this work, the upgrading potential of VFA mixtures of C4-C5-C6 acids under conditions representing real waste-based fermentation effluents (lower VFA concentrations) and a suboptimal current density (100 mA cm⁻²) was investigated. In addition, the effect of the initial VFA concentration ratios and the operation time (Faraday equivalents of FE = 0.25 and 1.0) on product selectivity and yields was studied. It was shown that mostly non-Kolbe products were formed – namely alcohols, esters and smaller amounts of ketones – in both experiments. An extended operation time favored ester and ketone formation, while alkanes (octane, nonane and decane) were presumably produced at the beginning of the electrolysis, since the process duration did not influence their yields. In addition, since butyric acid – the compound with the highest concentration in both model solutions – participated mostly in alcohol and ester formation, no butyrate radical dimerization (resulting in hexane) was observed. The results indicate that by not concentrating the VFAs in the fermentation effluents (via e.g. electrodialysis), the oxidative decarboxylation of VFAs at low/moderate current densities will likely result in non-Kolbe products.

02

Extracted values

Every value pulled from the paper, with its source, so each number can be checked against the text.

n = 42 extracted values

Select a citation to see the quote, page and confidence behind a value.

0 of 42 extracted rows modelable

  • 42 not canonicalised (no canonical slug)
ParameterValueUnitConfidenceSourceNotesModelable
Surface area of each Pt plate electrode2cm²95%
extracted
"two Pt plate electrodes with a surface area of 2 cm2 each" · electrode=Pt plate, current_density=100 mA cm-2Excluded: not canonicalised (no canonical slug)
Current density (galvanostatic)100mA cm⁻²95%
extracted
"ensuring a fixed current density of j = 100 mA cm-2" · ph=7, acids=["butyric acid","valeric acid","caproic acid"], electrode=Pt plate, 2 cm2 eachExcluded: not canonicalised (no canonical slug)
Transferred charge in experiment A1,000C95%
extracted
"In experiment A, the operation time was limited by the transfer of charge of Q =…" · ph=7, cell=100 mL glass bottle reactor, 80 mL solution, time=83 mins, acids=["butyric acid","valeric acid","caproic acid"]Excluded: not canonicalised (no canonical slug)
Operation time in experiment A83mins95%
extracted
"In experiment A, the operation time was limited by the transfer of charge of Q =…" · ph=7, cell=100 mL glass bottle reactor, 80 mL solution, time=83 mins, acids=["butyric acid","valeric acid","caproic acid"]Excluded: not canonicalised (no canonical slug)
Transferred charge in experiment B4,000C95%
extracted
"In experiment B, the transferred charge was Q = 4000 C corresponding to t = 333 …" · ph=7, cell=80 mL heart-shaped borosilicate glass reactor, 60 mL solution, time=333 mins, acids=["butyric acid","valeric acid","caproic acid"]Excluded: not canonicalised (no canonical slug)
Operation time in experiment B333mins95%
extracted
"In experiment B, the transferred charge was Q = 4000 C corresponding to t = 333 …" · ph=7, cell=80 mL heart-shaped borosilicate glass reactor, 60 mL solution, time=333 mins, acids=["butyric acid","valeric acid","caproic acid"]Excluded: not canonicalised (no canonical slug)
Solution pH set with NaOH7—95%
extracted
"The pH of the solution was set in both cases at 7 using 5 M NaOH" · ph=7 (adjusted with 5 M NaOH), acids=["butyric acid","valeric acid","caproic acid"], electrode=Pt plate, 2 cm2 each, current_density=100 mA cm-2Excluded: not canonicalised (no canonical slug)
Reaction media volume in experiment B60mL95%
extracted
"In experiment B, the reaction took place in an 80 mL heart-shaped borosilicate g…" · ph=7, cell=80 mL heart-shaped borosilicate glass reactor, 60 mL solution, time=333 mins, acids=["butyric acid","valeric acid","caproic acid"]Excluded: not canonicalised (no canonical slug)
Initial butyric acid (C4) concentration in experiment A0.23M95%
extracted
"The applied ratios of initial concentrations of C4:C5:C6 acids were 0.23:0.11:0.…" · ph=7, cell=100 mL glass bottle reactor, 80 mL solution, time=83 mins, acids=["butyric acid","valeric acid","caproic acid"]Excluded: not canonicalised (no canonical slug)
Initial valeric acid (C5) concentration in experiment A0.11M95%
extracted
"The applied ratios of initial concentrations of C4:C5:C6 acids were 0.23:0.11:0.…" · ph=7, cell=100 mL glass bottle reactor, 80 mL solution, time=83 mins, acids=["butyric acid","valeric acid","caproic acid"]Excluded: not canonicalised (no canonical slug)
Initial caproic acid (C6) concentration in experiment A0.083M95%
extracted
"The applied ratios of initial concentrations of C4:C5:C6 acids were 0.23:0.11:0.…" · ph=7, cell=100 mL glass bottle reactor, 80 mL solution, time=83 mins, acids=["butyric acid","valeric acid","caproic acid"]Excluded: not canonicalised (no canonical slug)
Initial valeric acid (C5) concentration in experiment B0.04M95%
extracted
"The applied ratios of initial concentrations of C4:C5:C6 acids were 0.23:0.11:0.…" · ph=7, cell=80 mL heart-shaped borosilicate glass reactor, 60 mL solution, time=333 mins, acids=["butyric acid","valeric acid","caproic acid"]Excluded: not canonicalised (no canonical slug)
Initial caproic acid (C6) concentration in experiment B0.077M95%
extracted
"The applied ratios of initial concentrations of C4:C5:C6 acids were 0.23:0.11:0.…" · ph=7, cell=80 mL heart-shaped borosilicate glass reactor, 60 mL solution, time=333 mins, acids=["butyric acid","valeric acid","caproic acid"]Excluded: not canonicalised (no canonical slug)
Reactor volume in experiment B80mL95%
extracted
"In experiment B, the reaction took place in an 80 mL heart-shaped borosilicate g…" · ph=7, cell=80 mL heart-shaped borosilicate glass reactor, 60 mL solution, time=333 mins, acids=["butyric acid","valeric acid","caproic acid"]Excluded: not canonicalised (no canonical slug)
Model VFA solution volume in experiment A80mL95%
extracted
"Kolbe electrolysis was carried out in a 100 mL customized Schott laboratory glas…" · ph=7, cell=100 mL glass bottle reactor, 80 mL solution, time=83 mins, acids=["butyric acid","valeric acid","caproic acid"]Excluded: not canonicalised (no canonical slug)
Reactor volume in experiment A100mL95%
extracted
"Kolbe electrolysis was carried out in a 100 mL customized Schott laboratory glas…" · ph=7, cell=100 mL glass bottle reactor, 80 mL solution, time=83 mins, acids=["butyric acid","valeric acid","caproic acid"]Excluded: not canonicalised (no canonical slug)
Yield of Kolbe dimers (alkanes), experiment A3.3%90%
gc-ms
"Kolbe dimers were formed with yields of only 3.3% and 3.4% for FE = 0.25 and FE …" · ph=7, cell=100 mL glass bottle reactor, 80 mL solution, time=83 mins, acids=["butyric acid","valeric acid","caproic acid"]Excluded: not canonicalised (no canonical slug)
Share of esters among the electrolysis products, experiment A11.7%90%
gc-ms
"Esters and alkanes accounted for 11.7 and 3.3%, respectively, moreover, a notabl…" · ph=7, cell=100 mL glass bottle reactor, 80 mL solution, time=83 mins, acids=["butyric acid","valeric acid","caproic acid"]Excluded: not canonicalised (no canonical slug)
Share of alkanes (Kolbe products) among the electrolysis products, experiment A3.3%90%
gc-ms
"Esters and alkanes accounted for 11.7 and 3.3%, respectively, moreover, a notabl…" · ph=7, cell=100 mL glass bottle reactor, 80 mL solution, time=83 mins, acids=["butyric acid","valeric acid","caproic acid"]Excluded: not canonicalised (no canonical slug)
Share of ketones among the electrolysis products, experiment A7%90%
gc-ms
"Esters and alkanes accounted for 11.7 and 3.3%, respectively, moreover, a notabl…" · ph=7, cell=100 mL glass bottle reactor, 80 mL solution, time=83 mins, acids=["butyric acid","valeric acid","caproic acid"]Excluded: not canonicalised (no canonical slug)
Share of alcohols among the electrolysis products, experiment B52.8%90%
gc-ms
"when FE = 1.0, alcohols were the dominant products accounting for 52.8%, while e…" · ph=7, cell=80 mL heart-shaped borosilicate glass reactor, 60 mL solution, time=333 mins, acids=["butyric acid","valeric acid","caproic acid"]Excluded: not canonicalised (no canonical slug)
Share of esters among the electrolysis products, experiment B18%90%
gc-ms
"when FE = 1.0, alcohols were the dominant products accounting for 52.8%, while e…" · ph=7, cell=80 mL heart-shaped borosilicate glass reactor, 60 mL solution, time=333 mins, acids=["butyric acid","valeric acid","caproic acid"]Excluded: not canonicalised (no canonical slug)
Share of alkanes (Kolbe products) among the electrolysis products, experiment B3.4%90%
gc-ms
"when FE = 1.0, alcohols were the dominant products accounting for 52.8%, while e…" · ph=7, cell=80 mL heart-shaped borosilicate glass reactor, 60 mL solution, time=333 mins, acids=["butyric acid","valeric acid","caproic acid"]Excluded: not canonicalised (no canonical slug)
Share of ketones among the electrolysis products, experiment B17.8%90%
gc-ms
"when FE = 1.0, alcohols were the dominant products accounting for 52.8%, while e…" · ph=7, cell=80 mL heart-shaped borosilicate glass reactor, 60 mL solution, time=333 mins, acids=["butyric acid","valeric acid","caproic acid"]Excluded: not canonicalised (no canonical slug)
Yield of octane (valeric acid homodimer), experiment A1.67%90%
gc-ms
"octane, nonane and decane could be obtained with yields of 1.67, 0.64 and 1.06% …" · ph=7, cell=100 mL glass bottle reactor, 80 mL solution, time=83 mins, acids=["butyric acid","valeric acid","caproic acid"]Excluded: not canonicalised (no canonical slug)
Showing 25 of 42

Pipeline

Raw extractions, artifacts, quality signal

Extraction quality

honesty signal

Calibrate your trust in the extracted content against these signals — they're how the pipeline rated its own output for this paper.

Mean parameter confidence

89%

Average confidence across PaperParameter rows surfaced above

review against source PDF before citing · scores 0–1

03

Chart explorer

Move the inputs this paper used and see how the predicted outcome shifts.

04

Explore model

The reactor in 3D, with flow you can switch on and off.

05

AI insights

Contradictions, gaps and opportunities found by comparing this paper with the corpus.

06

Compare similar papers

The nearest papers by system, materials and organisms, with their outcomes side by side.

07

Source PDF

The paper as published.

No 3D model is mapped to this paper yet. The values extracted from it are listed under Extracted values.

42
Extracted values
2025
Year

Keywords

  • volatile fatty acids
  • electrodialysis
  • butyrate
  • Kolbe electrolysis
  • Faradaic efficiency
  • alcohol formation
  • carboxylic acids
  • ketone formation

Cite

Tamás Rózsenberszki, Katalin Kucsera, Boglárka Bocska et al. (2025). Upgrading Potential of Waste Fermentation-Based C4-C5-C6 Carboxylic Acid Mixtures using Electrochemical Oxidative Decarboxylation. Hungarian Journal of Industry and Chemistry. https://doi.org/10.33927/hjic-2025-14