Research

Paper · MFC

Power Generation by Halophilic Bacteria and Assessment of the Effect of Salinity on Performance of a Denitrifying Microbial Fuel Cell

01

Summary

What the paper reports, in its own words.

3D Interactive ModelAI Enhanced· 78%Wastewater Treatment

Abstract

Saline wastewater pollution is a critical issue that needs to be addressed. The present study focused on the development of a dual-chambered microbial fuel cell (MFC) treating saline wastewater at the anode. Halophilic exo-electrogenic bacteria enriched from seawater (Arabian Sea, Mumbai, India) were used in the anodic chamber of the MFC. Denitrification using denitrifying bacteria was employed in the cathodic chamber. The maximum power density was significantly increased from 96.77 mW/m² to 162.09 mW/m² with a rise in NaCl concentration from 20 to 40 g/L. Nitrate removal in the cathode chamber increased from 80 ± 3% to 89 ± 3.2% with increase in salt concentration from 20 g/L to 40 g/L and concomitantly COD removal in the anode chamber increased from 76 ± 3.8% to 83 ± 4%. Cyclic voltammetry (CV) analysis revealed higher electrochemical activity at 40 g/L salt concentration. Electrochemical impedance spectroscopy (EIS) analysis exhibited that charge transfer and solution resistances were lower when the salinity was increased. Microbial community analysis revealed the presence of Clostridium, Shewanella, and Bacillus as the most abundant genera in the anodic chamber. This study demonstrated the dual applicability of the system targeted for removal of organics from saline wastewater and nitrate removal from contaminated wastewater accompanied by power generation from the MFC.

AI summary

78% confidence

This study operated a dual-chamber MFC with halophilic bacteria at the anode oxidizing acetate in saline wastewater (20–40 g/L NaCl) and denitrifying bacteria at the cathode reducing NO₃⁻-N (345 mg/L initial). Power density increased 1.7-fold from 96.77 to 162.09 mW/m² as salinity rose from 20 to 40 g/L, accompanied by improved COD removal (76→83%) and NO₃⁻-N removal (80→89%). Electrochemical analysis showed charge transfer resistance decreased from 20 to 16 Ω with higher salinity, enabling faster electron transfer. Coulombic efficiency remained low (12–14%), indicating substantial substrate loss to non-electricity pathways. The system successfully coupled organic oxidation with autotrophic denitrification under closed-circuit conditions.

Key insights

  • Threshold Increasing anode salinity from 20 to 40 g/L NaCl raised power density 1.7-fold (96.77→162.09 mW/m²) and reduced charge transfer resistance from 20 to 16 Ω, indicating ionic strength directly enhances electron transfer kinetics in halophilic biofilms.

    So what. Operators treating saline wastewater should target 40 g/L NaCl or higher to maximize power output, but must verify that the halophilic inoculum source tolerates the intended salinity range.

  • Trade-off COD removal rate increased from 550 to 625 mg/L/d (13.6% gain) when salinity rose from 20 to 40 g/L, but coulombic efficiency remained low at 12–14%, meaning 86–88% of substrate was consumed by non-exoelectrogenic pathways.

    So what. Higher salinity improves power output but does not proportionally improve substrate-to-electron conversion; operators should not assume that salinity optimization will reduce organic loading requirements.

  • Mechanism Nitrate removal improved from 80±3% to 89±3.2% (NO₃⁻-N basis) as salinity increased from 20 to 40 g/L, with removal rate rising from 110±4 to 124±3 mg/L/d, correlating directly with higher cathode current.

    So what. Denitrification rate in bioelectrochemical cathodes is current-limited; operators should prioritize anode-side conditions (salinity, substrate) that maximize current density to achieve target nitrate removal rates.

  • Mechanism Under open-circuit conditions, COD removal was only 28–32%, versus 76–83% under closed-circuit operation, demonstrating that electrons channeled to the electrode drive organic oxidation.

    So what. Closed-circuit operation is essential for efficient COD removal in this system; open-circuit or high-resistance modes will severely limit wastewater treatment performance.

  • Method Cyclic voltammetry showed oxidative peak current increased 1.7-fold (27.68→46.54 mA) at 40 g/L salinity, and reductive peak current increased 1.8-fold (−34.31→−62.97 mA), indicating higher biofilm electrochemical activity at elevated salinity.

    So what. Salinity enhancement of biofilm electroactivity is measurable via CV; use CV as a diagnostic tool to confirm that halophilic enrichment is responding to salinity changes.

Opportunity areas6

Specific gaps in this paper, with an experiment that would close each.

  • High No measurement of N₂O or NO₂⁻ accumulation during denitrification; incomplete nitrogen mass balance.

    Paper reports NO₃⁻-N removal (80–89%) but does not quantify end products or intermediate accumulation. Section 3.4 states 'autotrophic denitrification' but provides no gas chromatography or ion chromatography data for N₂O, NO, or NO₂⁻. This is critical for assessing whether the cathode is a complete denitrifier or a partial denitrifier.

    Try. Measure N₂O, NO, NO₂⁻, and N₂ via gas chromatography and ion chromatography across both salinity conditions; quantify nitrogen recovery to close mass balance.

  • High No systematic variation of cathode potential or applied voltage; operating window for denitrification not defined.

    Paper operated MFC at fixed 100 Ω external resistance and did not sweep cathode potential or apply external voltage. Section 3.4 notes that 'higher nitrate removal was caused by higher current' but does not isolate the effect of cathode potential (which drives denitrification kinetics) from anode potential (which drives current). Optimal cathode potential for complete denitrification vs. partial denitrification is unknown.

    Try. Vary cathode potential from −0.2 to −0.8 V vs. Ag/AgCl at fixed anode potential or fixed current; measure NO₃⁻-N removal, N₂O/NO₂⁻ accumulation, and current density.

  • Medium No variation of hydraulic retention time (HRT) or feed cycle duration; substrate depletion kinetics and limiting conditions not characterized.

    All experiments used 4-day fed-batch cycles with fixed initial COD (2900 mg/L) and NO₃⁻-N (345 mg/L). Section 3.1 shows voltage drops when acetate depletes, but no systematic study of how HRT affects COD removal rate, nitrate removal rate, or N₂O formation.

    Try. Operate at 2, 4, 6, and 8-day cycle lengths at both salinities; measure COD removal rate, NO₃⁻-N removal rate, and N₂O accumulation to identify optimal HRT window.

  • Medium No measurement of catholyte pH or dissolved oxygen; cathode microenvironment not characterized.

    Paper reports anolyte pH adjusted to 7.0±0.2 and catholyte pH adjusted to 7.0 initially, but does not monitor pH drift or dissolved oxygen during operation. Denitrification is pH-sensitive and can be inhibited by residual oxygen. Section 3.4 assumes autotrophic denitrification but does not verify anaerobic conditions or pH stability.

    Try. Monitor catholyte pH and dissolved oxygen continuously during fed-batch cycles at both salinities; correlate with NO₃⁻-N removal rate and N₂O accumulation.

  • Medium No variation of C/N ratio or initial NO₃⁻-N concentration; substrate limitation and electron acceptor limitation not distinguished.

    Fixed initial NO₃⁻-N at 345 mg/L and initial COD at 2900 mg/L (C/N ≈ 10 on molar basis). Paper does not test whether denitrification is limited by electron availability (current) or by nitrate availability. Section 3.4 states nitrate was 'supplemented at regular intervals' but does not specify when or how much.

    Try. Vary initial NO₃⁻-N from 100 to 500 mg/L at fixed COD (2900 mg/L) and fixed salinity (40 g/L); measure NO₃⁻-N removal rate and current density to identify electron acceptor limitation.

  • Medium Coulombic efficiency is very low (12–14%); substrate fate and competing pathways not investigated.

    Section 3.3 attributes low CE to 'microbial growth, non-electricity producing reactions, and formation of secondary microbial products' but provides no quantitative breakdown. No measurement of volatile fatty acids, biomass accumulation, or methane production.

    Try. Perform carbon balance: measure biomass (MLVSS), volatile fatty acids (HPLC), and biogas composition (GC) to account for the 86–88% of substrate not converted to current.

Generated by MESSAI extraction pipeline · review against source PDF

02

Extracted values

Every value pulled from the paper, with its source, so each number can be checked against the text.

n = 7 extracted values

Select a citation to see the quote, page and confidence behind a value.

0 of 5 extracted rows modelable

  • 3 not canonicalised (no canonical slug)
  • 2 no SI value
ParameterValueUnitConfidenceSourceModelable
Substratewastewater—80%
llm
Maximum power density162mW/m²80%
llm
Chambers2—80%
extracted
Excluded: not canonicalised (no canonical slug)
Reactor typedual-chamber—80%
extracted
Excluded: not canonicalised (no canonical slug)
Anode materialhalophilic exo-electrogenic bacteria enriched from seawater (arabian sea—70%
extracted
Excluded: no SI value
Cathode materialchamber increased from 80 ± 3% to 89 ± 3—70%
extracted
Excluded: no SI value
Microbial communityand assessment of the effect of salinity on performance of a denitrifying microbial fuel cell—50%
extracted
Excluded: not canonicalised (no canonical slug)

Methodology

What was the system and how was it run

Methodology

Methodology

Dual-chamber MFC (100 mL each) with carbon felt cathode and stainless-steel mesh anode, separated by Nafion-117 proton exchange membrane. Halophilic bacteria enriched from Arabian Sea seawater inoculated at anode; denitrifying bacteria from soil/manure at cathode. Fed-batch operation (4-day cycles, 7 cycles total) at two NaCl concentrations (20 and 40 g/L). Voltage and current measured continuously; COD and NO₃⁻-N quantified per cycle. Electrochemical characterization via cyclic voltammetry (−0.8 to +0.8 V, 10 mV/s) and electrochemical impedance spectroscopy (1 MHz to 10 mHz). Microbial community analysis via 16S rRNA gene sequencing (V3-V4 region, Illumina platform).

System configuration

FieldValue
reactor typeMFC
chamber config2-chamber

Biological parameters

FieldValue
microbial communityand assessment of the effect of salinity on performance of a denitrifying microbial fuel cell

Performance metrics

FieldValue
max power density162.09
citation count11

Operational parameters

FieldValue
substrate["wastewater"]

Electrochemical data

FieldValue
max power density96.77

Pipeline

Raw extractions, artifacts, quality signal

Extraction quality

honesty signal

Calibrate your trust in the extracted content against these signals — they're how the pipeline rated its own output for this paper.

Parameter completeness

75%

Fraction of expected parameters extracted

Reproducibility

43%

How reproducible the setup is from this paper alone

Data completeness

80%

Overall extraction coverage across fields

AI confidence

78%

Model self-reported confidence

Mean parameter confidence

73%

Average confidence across PaperParameter rows surfaced above

review against source PDF before citing · scores 0–1

03

Chart explorer

Move the inputs this paper used and see how the predicted outcome shifts.

04

Explore model

The reactor in 3D, with flow you can switch on and off.

05

AI insights

Contradictions, gaps and opportunities found by comparing this paper with the corpus.

06

Compare similar papers

The nearest papers by system, materials and organisms, with their outcomes side by side.

07

Source PDF

The paper as published.

loading 3D model…

Representative model, generic MFC

Representative MFC — matched on the paper’s system type only, not its reactor or geometry.

MFC
System
162milliwatts per square metre
Best result · Power density
best of 2
7
Extracted values
2023
Year

Keywords

  • Microbial fuel cell
  • Denitrifying bacteria
  • Wastewater
  • Seawater
  • Salinity
  • Halophile

Cite

Ankisha Vijay, Prakash C. Ghosh, Suparna Mukherji (2023). Power Generation by Halophilic Bacteria and Assessment of the Effect of Salinity on Performance of a Denitrifying Microbial Fuel Cell. Energies. https://doi.org/10.3390/en16020877

Journal
Energies

Open in lab for full controls, parameter editing, and template overlays.

Open in lab