Research

Paper · MFC

Performance of a Batch Operation Microbial Fuel Cell (MFC) with Cobalt Micronutrient Addition Based on Kinetic Models

01

Summary

What the paper reports, in its own words.

3D Interactive ModelAI Enhanced· 70%Power Generation

Abstract

The generation of electricity via MFC is subject to alteration by the concentration of the substrate. The objective of this study was to examine the performance of MFCs using both theoretical and experimental methods to ascertain the kinetic parameters associated with the addition of cobalt, with the aim of enhancing electricity generation via MFCs. The study demonstrated the impact of varying substrate concentrations and the composition of food waste and water, with formulas 0:5, 1:4, 2:3, 3:2, 4:1, and 5:0 (w/v). The kinetics of biochemical reactions were determined by employing the Monod and Gates-Marlar equations. The Monod equations were evaluated using three distinct representation methods. The Langmuir, Lineweaver-Burk, and Eadie-Hofstee models were employed. Conversely, the electrochemical reaction rate is evaluated through the Butler-Volmer equation. The current density derived from the theoretical approach exhibited a comparable pattern to that observed in the experimental data. The maximum power density was attained at a substrate concentration of 4:1 (w/v) exceeding 25,000 mW/m². The presented model facilitated the enhancement and optimization of MFC performance. Substrate concentration and biomass concentration exert a significant influence on MFC performance, as evidenced by the analysis of variance (ANOVA) and response surface methodology (RSM). Copyright © 2025 by Authors, Published by BCREC Publishing Group. This is an open access article under the CC BY-SA License (https://creativecommons.org/licenses/by-sa/4.0).

AI summary: matches the abstract (70% confidence) · review against source PDF

02

Extracted values

Every value pulled from the paper, with its source, so each number can be checked against the text.

n = 92 extracted values

Select a citation to see the quote, page and confidence behind a value.

6 of 92 extracted rows modelable

  • 6 not canonicalised (no canonical slug)
  • 76 no SI value
  • 3 outside physical bounds
  • 1 verifier rejected the value
ParameterValueUnitConfidenceSourceNotesModelable
Food Waste per Chamber0.5grams95%
extracted
"Every chamber of the MFC used 0.5 grams of food waste." · substrate=food_wasteExcluded: not canonicalised (no canonical slug)
Electrode Thickness2cm95%
extracted
"The anode and cathode were made of the same material, carbon cloth with dimensio…" · condition_hint=design parameter, electrode_material=carbon clothModelable
Electrode Thickness2mm95%
extracted
"The anode and cathode were made of the same material, carbon cloth with dimensio…" · condition_hint=design parameter, electrode_material=carbon clothModelable
Electrode Thickness5cm95%
extracted
"The anode and cathode were made of the same material, carbon cloth with dimensio…" · condition_hint=design parameter, electrode_material=carbon clothModelable
Cell Doubling Time20days95%
extracted
"During the process at MFC, voltage and current were measured for 20 days." · substrate=food_wasteModelable
Reactor Volume1.5liters95%
extracted
"The single-chamber MFC consisted of a chamber made of a plastic bottle (PET) wit…" · condition_hint=design parameter, electrode_material=carbon clothExcluded: no SI value
Anode Depth from Bottom3cm95%
extracted
"It consisted of an anode located 3 cm from the bottom of the chamber and a catho…" · condition_hint=design parameter, electrode_material=carbon clothExcluded: not canonicalised (no canonical slug)
Food Waste Composition - Protein30%90%
extracted
"The food waste used has a composition of 60% carbohydrate, 30% protein, and 10% …" · substrate=food_wasteExcluded: not canonicalised (no canonical slug)
Cobalt Micronutrient Concentration7μg/L90%
extracted
"Hydrolyzed food waste, Shewanella oneidensis MR-1 bacteria, Sidoarjo mud, and 7 …" · substrate=food_waste, startupExcluded: not canonicalised (no canonical slug)
Food Waste Composition - Fat10%90%
extracted
"The food waste used has a composition of 60% carbohydrate, 30% protein, and 10% …" · substrate=food_wasteExcluded: not canonicalised (no canonical slug)
Food Waste Composition - Carbohydrate60%90%
extracted
"The food waste used has a composition of 60% carbohydrate, 30% protein, and 10% …" · substrate=food_wasteExcluded: not canonicalised (no canonical slug)
Power density10,000W/m²90%
extracted
"the highest output was observed with substrate 4:1, which achieved a power densi…"Excluded: no SI value
Bacterial Population6billion cells/ml85%
extracted
"During the process, the effect of substrate concentration was taken into account…" · substrate=food_wasteExcluded: no SI value
Half Saturation Constant3.8g/L.days80%
eadie-hofstee plot analysis
"Table 3. The result of the kinetic parameters... KM (g/L.days) Eadie-Hofstee... …" · substrate=food_wasteExcluded: no SI value
Half Saturation Constant1.5g/L.days80%
langmuir plot analysis
"Table 3. The result of the kinetic parameters... KM (g/L.days) Langmuir... 3:2..…" · substrate=food_wasteExcluded: no SI value
Half Saturation Constant0.42g/L.days80%
eadie-hofstee plot analysis
"Table 3. The result of the kinetic parameters... KM (g/L.days) Eadie-Hofstee... …" · substrate=food_wasteExcluded: no SI value
Half Saturation Constant0.04g/L.days80%
eadie-hofstee plot analysis
"Table 3. The result of the kinetic parameters... KM (g/L.days) Eadie-Hofstee... …" · substrate=food_wasteExcluded: no SI value
Specific Growth Rate0.151/days80%
eadie-hofstee plot analysis
"Table 3. The result of the kinetic parameters... µmax (1/days) Eadie-Hofstee... …" · substrate=food_wasteExcluded: no SI value
Specific Growth Rate0.0181/days80%
langmuir plot analysis
"Table 3. The result of the kinetic parameters... µmax (1/days) Langmuir... 2:3..…" · substrate=food_wasteExcluded: no SI value
Half Saturation Constant1.3g/L.days80%
gates-marlar equation analysis
"Table 3. The result of the kinetic parameters... KM (g/L.days) Gates-Marlar... 0…" · substrate=food_wasteExcluded: no SI value
Specific Growth Rate0.481/days80%
lineweaver-burk plot analysis
"Table 3. The result of the kinetic parameters... µmax (1/days) Lineweaver-Burk..…" · substrate=food_wasteExcluded: no SI value
Specific Growth Rate1.071/days80%
langmuir plot analysis
"Table 3. The result of the kinetic parameters... µmax (1/days) Langmuir... 4:1..…" · substrate=food_wasteExcluded: no SI value
Specific Growth Rate0.41/days80%
eadie-hofstee plot analysis
"Table 3. The result of the kinetic parameters... µmax (1/days) Eadie-Hofstee... …" · substrate=food_wasteExcluded: no SI value
Specific Growth Rate0.281/days80%
langmuir plot analysis
"Table 3. The result of the kinetic parameters... µmax (1/days) Langmuir... 3:2..…" · substrate=food_wasteExcluded: no SI value
Half Saturation Constant5.11g/L.days80%
langmuir plot analysis
"Table 3. The result of the kinetic parameters... KM (g/L.days) Langmuir... 5:0..…" · substrate=food_wasteExcluded: no SI value
Showing 25 of 92

Methodology

What was the system and how was it run

Methodology

Methodology

The study employed the Monod and Gates-Marlar equations, Langmuir, Lineweaver-Burk, and Eadie-Hofstee models, and the Butler-Volmer equation to evaluate the kinetics of biochemical and electrochemical reactions.

System configuration

FieldValue
system typeMFC

Operational parameters

FieldValue
operating modebatch

Electrochemical data

FieldValue
max power density25

Operating conditions

7 runs extracted
RunT°CpHanpHcatSubstrate[S]mg/LHRThModeR_extΩV_appVInoculum
v2-17c786f3d2f4d22b———food_waste——steady_state1000——
v2-68f624ecfe00c86a———food_waste1.34——1000——
v2-83062ccfeecd5f03———food_waste——————
v2-9048e7c308b1f382———food_waste1.34—steady_state1000——
v2-d5409098375829d1———food_waste——startup1000——
v2-d700138926e20069———food_waste———1000——
v2-f586e9af22985397——————————

Microbial kinetics

5 constants
OrganismSubstrateParameterValueUnitConf.
Shewanella oneidensis MR-1tempeh wasteKs124milligrams per litre100%
unspecified(unspecified)Ks99.57milligrams per litre100%
unspecified(unspecified)Ks99.63milligrams per litre100%
unspecified(unspecified)Ks91.09milligrams per litre100%
unspecified(unspecified)Ks100.75milligrams per litre100%

Pipeline

Raw extractions, artifacts, quality signal

Extraction quality

honesty signal

Calibrate your trust in the extracted content against these signals — they're how the pipeline rated its own output for this paper.

Parameter completeness

38%

Fraction of expected parameters extracted

Data completeness

60%

Overall extraction coverage across fields

AI confidence

70%

Model self-reported confidence

Mean parameter confidence

75%

Average confidence across PaperParameter rows surfaced above

review against source PDF before citing · scores 0–1

03

Chart explorer

Move the inputs this paper used and see how the predicted outcome shifts.

04

Explore model

The reactor in 3D, with flow you can switch on and off.

05

AI insights

Contradictions, gaps and opportunities found by comparing this paper with the corpus.

06

Compare similar papers

The nearest papers by system, materials and organisms, with their outcomes side by side.

07

Source PDF

The paper as published.

loading 3D model…

Representative model, generic MFC

Representative MFC — matched on the paper’s system type only, not its reactor or geometry.

MFC
System
10000000milliwatts per square metre
Best result · Power density
best of 3
92
Extracted values
2024
Year

Keywords

  • Microbial fuel cell
  • Cobalt
  • Micronutrient
  • Kinetic energy
  • Waste management

Cite

Sri Rachmania Juliastuti, Fitria Nur Laily, Raden Darmawan (2024). Performance of a Batch Operation Microbial Fuel Cell (MFC) with Cobalt Micronutrient Addition Based on Kinetic Models. Bulletin of Chemical Reaction Engineering & Catalysis. https://doi.org/10.9767/bcrec.20259

Open in lab for full controls, parameter editing, and template overlays.

Open in lab