Paper · MFC
Investigation of the electrical potential of whey using a river sediment microbial fuel cell
- MFC
- Sediment
- Single Chamber
- Membraneless
- Mixed Culture
- Membrane: None
Summary
What the paper reports, in its own words.
Abstract
This study aimed to use whey and river sediment microbial fuel cells (SMFCs) to produce electrical potential, which has been investigated rarely in previous studies. In this study, the majority of the microorganisms in the river SMFC mixed culture were Bacteroides and Clostridium. After the voltage and internal resistance were measured, the current and power density were calculated. The power density (279*10⁻³ mW/cm² ) and maximum current density (1100*10⁻⁶ mA/cm² ) were determined through computations. Bacteria present in river SMFCs showed the potential to generate electricity without any external mediators. By utilizing organic materials, bioelectricity can be produced affordably and sustainably. KEY WORDS: Electrical potential, SMFC, Treatment, Whey, River sediment Bull. Chem. Soc. Ethiop. 2024, 38(5), 1479-1491. DOI: https://dx.doi.org/10.4314/bcse.v38i5.22
AI summary: matches the abstract (70% confidence) · review against source PDF
Key findings
- The river sediment microbial fuel cells showed potential to generate electricity without external mediators.
- Organic materials can be used to produce bioelectricity affordably and sustainably.
Extracted values
Every value pulled from the paper, with its source, so each number can be checked against the text.
n = 66 extracted values
Select a citation to see the quote, page and confidence behind a value.
27 of 65 extracted rows modelable
- 23 not canonicalised (no canonical slug)
- 14 no SI value
- 1 outside physical bounds
| Parameter | Value | Unit | Confidence | Source | Notes | Modelable |
|---|---|---|---|---|---|---|
| Peak Current | 1,100 | 10⁻⁶ mA/cm² | 90% | llm | results | |
| Current density | 0.0011 | mA/cm² | 100% | extracted | "The current and power density were calculated from the results obtained." | Excluded: no SI value |
| Power density | 0.279 | mW/cm² | 100% | extracted | "The current and power density were calculated from the results obtained." | Excluded: no SI value |
| Temperature | 17 | °C | 90% | temperature meter (amt-300) | "The conductivity, pH, TDS, and temperature were determined, and the results are …" · T=17°C | Modelable |
| Fe2O3 Content | 4.6 | % | 90% | x-ray fluorescence (xrf) | "Additionally, the sand contains 4.6% Fe2O3, which is naturally present in the sa…" · substrate=river_sediment | Excluded: not canonicalised (no canonical slug) |
| Total Suspended Solids | 3,710 | ppm | 90% | tds meter (tds-3 tds/temp meter) | "The conductivity, pH, TDS, and temperature were determined, and the results are …" · substrate=whey, steady_state | Modelable |
| Temperature×2 | 16 | °C | 90% | temperature meter (amt-300) | "The conductivity, pH, TDS, and temperature were determined, and the results are …" · T=16°C, substrate=whey | Modelable |
| Lipid Content | 2.2 | % | 90% | x-ray fluorescence (xrf) | "In addition, the sand included 2.7% Na2O and 2.2% CaO." · substrate=river_sediment | Modelable |
| Electrode Surface Area×2 | 15 | cm | 90% | extracted | "Electrodes with a diameter of 15 cm for the anode and cathode were formed from a…" · condition_hint=electrode design parameter, electrode_material=aluminum foil paper | Excluded: no SI value |
| Total Suspended Solids | 2,190 | ppm | 90% | tds meter (tds-3 tds/temp meter) | "The conductivity, pH, TDS, and temperature were determined, and the results are …" · substrate=whey | Modelable |
| Inoculum Volume | 2 | mL | 90% | extracted | "After a minute in an ultrasonic cleaner for the removal from the surface, two mi…" · substrate=river_sediment, startup | Modelable |
| pH | 5.7 | — | 90% | ph meter (ph-009(i)a pen type ph meter) | "The conductivity, pH, TDS, and temperature were determined, and the results are …" · pH(an)=5.7, substrate=whey, steady_state | Modelable |
| pH | 4.3 | — | 90% | ph meter (ph-009(i)a pen type ph meter) | "The conductivity, pH, TDS, and temperature were determined, and the results are …" · pH(an)=4.3, substrate=whey | Modelable |
| Relative Abundance | 18.7 | % | 90% | metagenomic analysis | "The microorganisms were mixed in culture, as shown in Figure 1. However, most of…" · substrate=river_sediment | Modelable |
| Reactor Volume | 5 | L | 90% | extracted | "In the system, a 5-cm-thick layer of sand was placed on the bottom of a 5-liter …" · condition_hint=reactor design parameter | Modelable |
| Electrode Spacing | 5 | cm | 90% | extracted | "In other words, a distance of 5 cm was left between the anode and cathode." · condition_hint=reactor design parameter | Modelable |
| Al2O3 Content | 10.5 | % | 90% | x-ray fluorescence (xrf) | "After silica, the sand contains the most Al2O3 (alumina), and it can be found in…" · substrate=river_sediment | Excluded: not canonicalised (no canonical slug) |
| Electrical Conductivity | 7.76 | mS/cm | 90% | conductivity meter (c65 waterproof ec pens) | "The effluent had an initial chemical oxygen demand (COD) of 51 g/L, while its co…" · T=25°C, pH(an)=6, substrate=whey | Modelable |
| Whey Volume Added | 50 | mL | 90% | extracted | "After heating the whey sample to 100 °C and cooling, 50 mL of undiluted whey wer…" · substrate=whey, startup | Excluded: not canonicalised (no canonical slug) |
| Electrical Conductivity | 5,840 | μS/cm | 90% | conductivity meter (c65 waterproof ec pens) | "The conductivity, pH, TDS, and temperature were determined, and the results are …" · substrate=whey | Modelable |
| Temperature | 14 | °C | 90% | temperature meter (amt-300) | "The conductivity, pH, TDS, and temperature were determined, and the results are …" · T=14°C, substrate=whey, steady_state | Modelable |
| Na2O Content | 2.7 | % | 90% | x-ray fluorescence (xrf) | "In addition, the sand included 2.7% Na2O and 2.2% CaO." · substrate=river_sediment | Excluded: not canonicalised (no canonical slug) |
| Sediment Layer Thickness | 5 | cm | 90% | extracted | "In the system, a 5-cm-thick layer of sand was placed on the bottom of a 5-liter …" · substrate=river_sediment | Excluded: not canonicalised (no canonical slug) |
| Dissolved Oxygen | 73.9 | % | 90% | x-ray fluorescence (xrf) | "The XRF results show that the sand contains 73.9% silica, as shown in Table 1." · substrate=river_sediment | Excluded: no SI value |
| Volatile Solids | 2.3 | % | 90% | x-ray fluorescence (xrf) | "The organic matter content of the sand is 2.3% of its chemical structure." · substrate=river_sediment | Excluded: no SI value |
Methodology
What was the system and how was it run
Methodology
Methodology
The study used a river sediment microbial fuel cell to measure the electrical potential of whey.
System configuration
| Field | Value |
|---|---|
| reactor type | single-chamber |
| chamber config | single |
| membrane type | CEM |
Electrode specifications
| Field | Value |
|---|---|
| anode material | Au |
| anode vendor | this system [10] |
| cathode material | Pt |
| catalyst details | TiO2 |
| materials vendors | 7 entries |
Biological parameters
| Field | Value |
|---|---|
| inoculum source | pure culture |
| dominant species | 3 entries |
| community analysis | metagenomics |
Electrochemical data
| Field | Value |
|---|---|
| max power density | 30000 |
Operating conditions
19 runs extracted| Run | T°C | pHan | pHcat | Substrate | [S]mg/L | HRTh | Mode | R_extΩ | V_appV | Inoculum |
|---|---|---|---|---|---|---|---|---|---|---|
| baseline | — | — | — | cheese_whey | — | — | — | — | — | river sediment |
| baseline #2 | — | — | — | cheese_whey | — | — | — | — | — | river sediment |
| C01: River sediment SMFC with cheese whey, aluminum foil electrodes, 5L beaker, 17-day operation | 16 | 4.3 | — | — | — | — | — | — | — | river sediment |
| v2-202b1f8ba4447edf | — | 5.7 | — | whey | — | — | steady_state | — | — | — |
| v2-2a45fa4435665c50 | — | — | — | whey | — | — | steady_state | — | — | — |
| v2-477910157f8fa940 | — | — | — | river_sediment | — | — | — | — | — | — |
| v2-60eab1d4e804c5a4 | 14 | — | — | whey | — | — | steady_state | — | — | — |
| v2-63b76acd4765aebc | — | — | — | whey | — | — | startup | — | — | — |
| v2-6b2ebfe8d6c52f8a | 16 | — | — | whey | — | — | — | — | — | — |
| v2-81ce62c90812a94f | — | — | — | whey | — | — | — | — | — | — |
| v2-85a1c21ee8495a42 | — | — | — | cheese whey | — | — | — | — | — | — |
| v2-8abc7cef3dede1b6 | 17 | 5.7 | — | whey | — | — | steady_state | — | — | — |
| v2-8c72750ddb18534e | 16 | — | — | — | — | — | steady_state | — | — | — |
| v2-964a8f2d348df3ad | 17 | — | — | — | — | — | — | — | — | — |
| v2-a0989b16d73464d1 | — | — | — | river_sediment | — | — | startup | — | — | — |
| v2-c26898ece3400b70 | 25 | 6 | — | whey | — | — | — | — | — | — |
| v2-c9cc38a82877d76c | — | — | — | whey | — | — | transient | — | — | — |
| v2-f586e9af22985397 | — | — | — | — | — | — | — | — | — | — |
| v2-f9d13a4b1cf9d532 | — | 4.3 | — | whey | — | — | — | — | — | — |
Pipeline
Raw extractions, artifacts, quality signal
Extraction quality
honesty signalCalibrate your trust in the extracted content against these signals — they're how the pipeline rated its own output for this paper.
Parameter completeness
38%
Fraction of expected parameters extracted
Data completeness
50%
Overall extraction coverage across fields
AI confidence
70%
Model self-reported confidence
Mean parameter confidence
72%
Average confidence across PaperParameter rows surfaced above
review against source PDF before citing · scores 0–1
Chart explorer
Move the inputs this paper used and see how the predicted outcome shifts.
Explore model
The reactor in 3D, with flow you can switch on and off.
AI insights
Contradictions, gaps and opportunities found by comparing this paper with the corpus.
Compare similar papers
The nearest papers by system, materials and organisms, with their outcomes side by side.
Source PDF
The paper as published.
Representative model: Sediment MFC
Tap to interactRepresentative model: Sediment MFC
Representative sediment MFC — matched on the paper’s reported configuration, not its exact geometry.
In this record
Organisms, parameters and materials this paper reports. Each links to its page.
Organisms · 3
- mixed culture (Bacteroides, Clostridium)
- Bacteroides
- Clostridium Butyricum
Materials · 1
Keywords
- Microbial fuel cell
- Sediment
- Microorganism
- Environmental chemistry
- Power density
- Bacteria
Cite
Esra Ateş, Selim Latif Sanin (2024). Investigation of the electrical potential of whey using a river sediment microbial fuel cell. Bulletin of the Chemical Society of Ethiopia. https://doi.org/10.4314/bcse.v38i5.22
Open in lab for full controls, parameter editing, and template overlays.
Open in lab