Research

Paper · MFC

Effect of Different Mediators on Bio-Energy Generation and Palm Oil Mill Effluent Treatment in an Air-Cathode Microbial Fuel Cell-Adsorption System

01

Summary

What the paper reports, in its own words.

3D Interactive ModelAI Enhanced· 70%Wastewater Treatment

Abstract

Palm oil mill effluent (POME) discharged without treatment into watercourses can pollute the water source. Microbial fuel cell (MFC) has gained high attention as a green technology of converting organic wastewater into bio-energy. As an approach to overcome the limitations of the existing POME treatment methods, air-cathode MFC-Adsorption system is introduced as an innovative technology to treat POME and generate bio-electricity simultaneously. However, the use of conventional MFC with proton exchange membrane in large scale applications is restricted by the high cost and low power generation. Addition of mediator in MFC is essential in order to increase the electron transfer efficiency, hence enhancing the system performance. This study therefore aims to investigate the effect of different type of mediators i.e. congo red (CR), crystal violet (CV) and methylene blue (MB) on the performance of an affordable air-cathode MFC-Adsorption system made from earthen pot with POME as the substrate. The addition of different mediators altered the pH of the MFC-Adsorption system, in which more alkaline system showed better performance. The voltage generated in the system with CR, CV and MB mediator was 120.58 mV, 168.63 mV and 189.25 mV whereas the current generated was 2.41 mA, 3.37 mA and 3.79 mA, respectively. The power density of 290.79 mW/m³, 568.72 mW/m³ and 716.31 mW/m³ was produced in the MFC-Adsorption system with CR, CV and MB mediator, respectively. The highest POME treatment efficiency was achieved in MFC-Adsorption system with MB mediator, which resulted in biochemical oxygen demand, chemical oxygen demand, total suspended solids, turbidity and ammoniacal nitrogen removal of 75.3%, 84.8%, 91.5%, 86.1% and 23.31%, respectively. Overall, the air-cathode MFC-Adsorption system with addition of MB mediator was feasible for POME treatment and simultaneous bio-energy generation.

AI summary: matches the abstract (70% confidence) · review against source PDF

Key findings

  • The air-cathode MFC-Adsorption system made from earthen pot with POME as substrate showed promising results in treating POME and generating bio-electricity.
02

Extracted values

Every value pulled from the paper, with its source, so each number can be checked against the text.

n = 5 extracted values

Select a citation to see the quote, page and confidence behind a value.

0 of 4 extracted rows modelable

  • 4 no SI value
ParameterValueUnitConfidenceSourceModelable
Substratewastewater—80%
llm
Membrane materialPEM—80%
extracted
Excluded: no SI value
Cathode materialair-cathode—60%
extracted
Excluded: no SI value
Cathode materialearthen pot—50%
extracted
Excluded: no SI value
Membrane materialproton exchange membrane—50%
extracted
Excluded: no SI value

Methodology

What was the system and how was it run

Methodology

Methodology

The study used an air-cathode MFC-Adsorption system made from earthen pot with POME as substrate and investigated the effect of different mediators on its performance.

System configuration

FieldValue
chamber configurationair-cathode
system typeMFC

Performance metrics

FieldValue
citation count3

Operational parameters

FieldValue
substrate["wastewater"]

Pipeline

Raw extractions, artifacts, quality signal

Extraction quality

honesty signal

Calibrate your trust in the extracted content against these signals — they're how the pipeline rated its own output for this paper.

Parameter completeness

38%

Fraction of expected parameters extracted

Data completeness

60%

Overall extraction coverage across fields

AI confidence

70%

Model self-reported confidence

Mean parameter confidence

64%

Average confidence across PaperParameter rows surfaced above

review against source PDF before citing · scores 0–1

03

Chart explorer

Move the inputs this paper used and see how the predicted outcome shifts.

04

Explore model

The reactor in 3D, with flow you can switch on and off.

05

AI insights

Contradictions, gaps and opportunities found by comparing this paper with the corpus.

06

Compare similar papers

The nearest papers by system, materials and organisms, with their outcomes side by side.

loading 3D model…

Representative model, generic MFC

Representative MFC — matched on the paper’s system type only, not its reactor or geometry.

MFC
System
5
Extracted values
2021
Year

Keywords

  • Pome
  • Microbial fuel cell
  • Adsorption
  • Pulp and paper industry
  • Cathode
  • Wastewater

Cite

Ivy Ai Wei Tan, J.R. Selvanathan, M.O. Abdullah et al. (2021). Effect of Different Mediators on Bio-Energy Generation and Palm Oil Mill Effluent Treatment in an Air-Cathode Microbial Fuel Cell-Adsorption System. Defect and Diffusion Forum. https://doi.org/10.4028/www.scientific.net/ddf.411.67

Open in lab for full controls, parameter editing, and template overlays.

Open in lab