Research

Paper

Link between capacity for current production and syntrophic growth in Geobacter species

01

Summary

What the paper reports, in its own words.

Abstract

Electrodes are unnatural electron acceptors, and it is yet unknown how some Geobacter species evolved to use electrodes as terminal electron acceptors. Analysis of different Geobacter species revealed that they varied in their capacity for current production. Geobacter metallireducens and G. hydrogenophilus generated high current densities (ca. 0.2 mA/cm²), comparable to G. sulfurreducens. G. bremensis, G. chapellei, G. humireducens, and G. uraniireducens, produced much lower currents (ca. 0.05 mA/cm²) and G. bemidjiensis was previously found to not produce current. There was no correspondence between the effectiveness of current generation and Fe(III) oxide reduction rates. Some high-current-density strains (G. metallireducens and G. hydrogenophilus) reduced Fe(III)-oxides as fast as some low-current-density strains (G. bremensis, G. humireducens, and G. uraniireducens) whereas other low-current-density strains (G. bemidjiensis and G. chapellei) reduced Fe(III) oxide as slowly as G. sulfurreducens, a high-current-density strain. However, there was a correspondence between the ability to produce higher currents and the ability to grow syntrophically. G. hydrogenophilus was found to grow in co-culture with Methanosarcina barkeri, which is capable of direct interspecies electron transfer (DIET), but not with Methanospirillum hungatei capable only of H2 or formate transfer. Conductive granular activated carbon (GAC) stimulated metabolism of the G. hydrogenophilus - M. barkeri co-culture, consistent with electron exchange via DIET. These findings, coupled with the previous finding that G. metallireducens and G. sulfurreducens are also capable of DIET, suggest that evolution to optimize DIET has fortuitously conferred the capability for high-density current production to some Geobacter species.

02

Extracted values

Every value pulled from the paper, with its source, so each number can be checked against the text.

n = 22 extracted values

Select a citation to see the quote, page and confidence behind a value.

6 of 22 extracted rows modelable

  • 14 not canonicalised (no canonical slug)
  • 1 no SI value
  • 1 verifier rejected the value
ParameterValueUnitConfidenceSourceNotesModelable
Current Density (Basis Unresolved)0mA/cm²90%
extracted
"Furthermore, G. bemidjiensis was unable to produce current" · substrate=acetateExcluded: verifier rejected the value
Current Density (Basis Unresolved)×20.2mA/cm²90%
extracted
"G. metallireducens (Figure 1) and G. hydrogenophilus (Figure 1) both produced cu…" · substrate=acetateModelable
Current Density (Basis Unresolved)×40.05mA/cm²90%
extracted
"all the other strains tested generated much lower (ca. 0.05 mA/cm2) maximum curr…" · substrate=acetateModelable
Maximum Fe(III) oxide reduction rate0.15mM Fe(II) per hour90%
extracted
"G. metallireducens and G. hydrogenophilus, which produced high current densities…" · substrate=acetateExcluded: not canonicalised (no canonical slug)
Maximum Fe(III) oxide reduction rate0.33mM Fe(II) per hour90%
extracted
"G. metallireducens and G. hydrogenophilus, which produced high current densities…" · substrate=acetateExcluded: not canonicalised (no canonical slug)
Maximum Fe(III) oxide reduction rate0.44mM Fe(II) per hour90%
extracted
"three other species with low current outputs, G. bremensis, G. humireducens, and…" · substrate=acetateExcluded: not canonicalised (no canonical slug)
Maximum Fe(III) oxide reduction rate0.16mM Fe(II) per hour90%
extracted
"three other species with low current outputs, G. bremensis, G. humireducens, and…" · substrate=acetateExcluded: not canonicalised (no canonical slug)
Maximum Fe(III) oxide reduction rate0.23mM Fe(II) per hour90%
extracted
"three other species with low current outputs, G. bremensis, G. humireducens, and…" · substrate=acetateExcluded: not canonicalised (no canonical slug)
Maximum Fe(III) oxide reduction rate0.02mM Fe(II) per hour90%
extracted
"G. chapellei and G. bemidjiensis, two species that produced low currents, slowly…" · substrate=acetateExcluded: not canonicalised (no canonical slug)
Maximum Fe(III) oxide reduction rate0.04mM Fe(II) per hour90%
extracted
"G. chapellei and G. bemidjiensis, two species that produced low currents, slowly…" · substrate=acetateExcluded: not canonicalised (no canonical slug)
Fe(III) oxide reduction rate0.02mM Fe(II) per hour90%
extracted
"In contrast G. sulfurreducens, which is also highly effective in current product…" · substrate=acetateExcluded: not canonicalised (no canonical slug)
Electron transfer acceleration1qualitative90%
extracted
"GAC greatly accelerated electron transfer between G. hydrogenophilus and M. bark…" · substrate=ethanolExcluded: not canonicalised (no canonical slug)
Co-culture establishment×50—90%
extracted
"Of the Geobacter species evaluated, only G. hydrogenophilus successfully establi…" · substrate=ethanolExcluded: not canonicalised (no canonical slug)
CH₄ Production Rate0.9μmol per day90%
extracted
"The rates of methane production (0.9 ± 0.6 μmol per day) by G. hydrogenophilus c…" · substrate=ethanolExcluded: no SI value

Methodology

What was the system and how was it run

Operating conditions

2 runs extracted
RunT°CpHanpHcatSubstrate[S]mg/LHRThModeR_extΩV_appVInoculum
v2-1e145e1f5b0387de———ethanol——————
v2-ddef03b9967b441c———acetate——————

Pipeline

Raw extractions, artifacts, quality signal

Extraction quality

honesty signal

Calibrate your trust in the extracted content against these signals — they're how the pipeline rated its own output for this paper.

Mean parameter confidence

90%

Average confidence across PaperParameter rows surfaced above

review against source PDF before citing · scores 0–1

03

Chart explorer

Move the inputs this paper used and see how the predicted outcome shifts.

04

Explore model

The reactor in 3D, with flow you can switch on and off.

05

AI insights

Contradictions, gaps and opportunities found by comparing this paper with the corpus.

06

Compare similar papers

The nearest papers by system, materials and organisms, with their outcomes side by side.

07

Source PDF

The paper as published.

No 3D model is mapped to this paper yet. The values extracted from it are listed under Extracted values.

2.00amperes per square metre
Best result · Current density
best of 7
22
Extracted values
2015
Year

In this record

Organisms, parameters and materials this paper reports. Each links to its page.

Keywords

  • Production (economics)
  • Geobacter
  • Current (fluid)
  • Geobacter sulfurreducens
  • Biochemical engineering
  • Biology
  • Environmental science
  • Chemistry
  • Bacteria
  • Economics
  • Geology
  • Genetics
  • Microeconomics
  • Engineering

Cite

Amelia‐Elena Rotaru, Trevor L. Woodard, Kelly P. Nevin et al. (2015). Link between capacity for current production and syntrophic growth in Geobacter species. Frontiers in Microbiology. https://doi.org/10.3389/fmicb.2015.00744